Honda ► TLR200 ►
-
Here’s our hand-picked list of parts and accessories for your Honda TLR200 with universal parts included►
- Honda
Valve Stem Seal
Valve Stem Seal OEM Ref # 12208-413-003 / 12209-KL4-005 / 12209-428-003
Oil Filter Screen
Oil Filter Screen, Replaces OEM# 15421-107-000
Piston Pin Clips
Piston Pin Clips, 15mm (Pk/2) - Japanese made Superior Quality OEM Ref. # 94601-15000
Cam Chain Tensioner
Cam Chain Tensioner, Replaces OEM# 14500-427-000
Cam Chain Guide
Cam Chain Guide, Replaces OEM# 14550-427-000
Clutch Lever
Clutch Lever OEM Ref # 53178-KE1-000
Brake Lever Perch
Brake Lever Perch, Replaces OEM# 53171-KE1-000
Tail Light Lens
Tail Light Lens, Replaces OEM# 33702-MC4-671 / 33702-MGR-305
Tail Light Assembly
Tail Light Assembly, Replaces OEM# 33701-KB7-003 / 33701-MC4-671 / 33701-GAN-671 This Tail Light Does Not Have Reflectors on the Sides of the Lens. 102mm center to center of the rear thread in holes.
Tail Light Lens
Tail Light Lens, Replaces OEM# 33702-MC4-671 / 33702-KB7-003 / 33702-KB7-013 / 33702-MGR-305 / 33702-GF4-000 / 33702-MG2-942 This Tail Light Does Not Have Reflectors on the Sides of the Lens.
Turn Signal Lamp
Turn Signal Lamp - Black Left Front Single Filament - 12 Volt OEM Ref # 33350-MG2-671
Turn Signal Lamp
Turn Signal Lamp - Black Right Front Single Filament - 12 Volt OEM Ref # 33300-MG2-671
Fuel Petcock
Fuel Petcock Assembly, Replaces OEM# 16950-GF6-015 / 16950-163-035 / 16950-GW8-670 / 16950-149-025 / 16950-195-702 / 16950-150-000 / 16950-164-015 / 16950-164-025 / 16950-164-035 / 16950-KE6-830 Fits M14 x 1.0
Engine Gasket Set
Complete Engine Gasket Set Includes all Engine Gaskets High Quality - Made In Italy by Athena Athena Product # P400210850200
Kick Starter Lever
Kick Starter Lever, Replaces OEM#28300-427-770 / 28300-437-000 / 28300-KJ2-000 16mm spline, ensure this is the size you need for your bike before purchase.
Gas Tank Cap
Gas Tank Cap with Keys, Replaces OEM# 17620-KE1-013 / 17620-MN9-013 / 17620-MN9-023 Slightly different then stock - This cap has the vent on the side instead of the top and is a locking type while the stock one was not. Diameter of 3.5"
Carb Float
Brass Carb Float with Pin - Replaces OEM# 16013-286-014 Fits VM29/33 Smoothbores & most OEM CV/VM Mikuni carbs Used on Yamaha & Kawasaki up to 1980 and some Honda's
Spark Plug Ignition Coil Cap Boot
Spark Plug Ignition Coil Cap Boot, Replaces OEM# 30700-MA0-163 / 30700-MC4-153 / 30700-MA0-153 / 30700-KA2-003 / 30700-HM5-630 / 30700-965-003 / 30700-965-013. Angle = 120 Degrees Height = 40mm or 1.57" Length = 59mm or 2.23" Resistor = 5k OHM
Fork Seals
Fork Seals Set/2 35 X 48 X 10.5/11
Fork Seals
Fork Seals Set/2 33 X 46 X 11
Cotter Valve / Valve Keeper
Cotter Valve / Valve Keeper, Replaces OEM# 14781-107-003 / 14781-107-020. 2 Used For Each Valve Spring. Sold Each, Order the Quantity you Require
Rear Brake Shoes
Rear Brake Shoes Pk/2 Diameter: 94mm Width: 20mm OEM Ref # 43120-GE1-671
Brake Rod Spring
Brake Rod Spring. Replaces OEM # 95014-73100
Clutch Center Nut Removal Tool
Clutch Center Nut Removal Tool, The perfect tool for easier removal/fitting, without damaging the special locking nut. Inside diameter 24mm, use with 3/8" driver.
Clutch Center Nut Removal Tool ~ Premium
Premium Clutch Center Nut Removal Tool, The perfect tool for easier removal/fitting, without damaging the special locking nut. Both ends with 1/2 drive extension bar, Diameter 20 x 24.