Honda ► CB400F ►
-
Here’s our hand-picked list of electrical parts for your Honda CB400F with universal parts included that match “honda sl125”►
- Honda
Turn Signal Lamp
Turn Signal Lamp - Glossy Black 3 Wire - Dual Filament Left Front / Right Rear * For Single Filament, Use 2 of 3 Wire *
Turn Signal Lamp
Turn Signal Lamp - Glossy Black 3 Wire - Dual Filament Right Front / Left Rear * For Single Filament, Use 2 of 3 Wire *
Tail Light Lens
Tail Light Lens, Replaces OEM# 33702-MC4-671 / 33702-MGR-305
Rear Signal Stem
Rear Signal Stem OEM Ref # 33691-MJ0-003
Ignition Coil
Ignition Coil, Replaces OEM # 30510-KT7-023 Dual Output, 12 Volt, 2.20 Ohm Coil
Turn Signal Flasher Relay
Turn Signal Flasher Relay, Replaces OEM# 38301-MG9-681 / 38301-KK9-952 / 38301-KK9-951 / 38301-MF8-773 / 38301-MF8-772 / 38301-MB0-004 / 38301-MG9-671.
Lever Safety Stop Switch
Front Clutch Lever Safety Stop Switch, Replaces OEM # 35330-413-003 This is the switch that allows the bike to start when the clutch lever is depressed.
Turn Signal Replacement Lens
Turn Signal Replacement Lens - Amber - Front o& Rear OEM Ref # 33406-MB2-601 / 33406-MB2-671
Tail Light Lens
Tail Light Lens, Replaces OEM# 33702-MC4-671 / 33702-KB7-003 / 33702-KB7-013 / 33702-MGR-305 / 33702-GF4-000 / 33702-MG2-942 This Tail Light Does Not Have Reflectors on the Sides of the Lens.
Starter Clutch Diode
Starter Clutch Diode OEM Ref # 31700-124-003 / 31700-166-008
Radiator Fan Switch
Radiator Fan Switch, Replaces OEM # 37760-MR1-003 / 37760-MT2-003
Starter Motor Terminal Rubber Boot
Starter Motor Terminal (Cover) Rubber Boot. Replaces OEM # 32411-230-000
Hydraulic Brake Light Switch
Hydraulic Brake Light Switch Banjo Bolt Type - 10mm x M1.25 Can Be Used Front/Rear At Single Banjo Brake Line Fitting Correct Thread For Most Honda/Kawasaki/Yamaha Stock Fittings
Universal 1 Ohm Dual Output 6V Ignition Coil
Universal 1 Ohm Dual Output 6V Ignition Coil. Will work on a number of Honda, Kawasaki, Suzuki, Yamaha, Norton, BSA, Triumph and other motorcycles with 6 volt dual output ignition coils. Check the coil mount spacing on your bike before you order. Mounting holes are 90mm (3.5") apart center to center. Low tension wires 390mm (15") long. Female spade connectors at the coil and male and female bullet connectors at the other ends. Spark plug wires (high tension leads) 570mm (24") long with 300mm (12") protective sheath.