Honda ► CB750K ►
-
Here’s our hand-picked list of parts and accessories for your Honda CB750K with universal parts included that match “wire harness”►
- Honda
Handlebar - Stock Type ~ CB750K 1973-76 / CB750F 1975-76
Stock Type Handlebar for the CB750K (1973-76), CB750F (1975-76) - Chrome. Drilled for wires like the OEM type. Width 32" - Rise 7" - Pullback 4" x 7/8"Dia. Replaces OEM # 53100-341-700 Note: These Are Drilled For Wires
Bar Switch Assembly ~ Right (Brake) Side
Bar Switch Assembly ~ Right (Brake) Side - Black. Replaces OEM # 35300-300-672 Note: Wiring to be run Inside the handlebar. This is a single throttle cable configuration type assembly.
Bar Switch Assembly ~ Left (Clutch) Side
Bar Switch Assembly ~ Left (Clutch) Side - Black. Replaces OEM # 35200-404-671 Note: This handlebar switch assembly requires the wires to be run inside the handlebar
Universal Bar Switch Assembly ~ Left (Clutch) Side
Universal Bar Switch Assembly ~ Left (Clutch) Side. Clutch side universal handlebar switch for 7/8" bars. Simple and clean design with the essentials. Includes headlight hi-low, turn signal and horn buttons. Includes 8 female bullet connectors, you may need to adapt the connectors to fit your wire harness.
Universal Bar Switch Assembly ~ Right (Brake) Side
Universal Bar Switch Assembly ~ Right (Brake) Side. Brake side universal handlebar switch for 7/8" bars. Simple and clean design with the essentials. Includes momentary starter, kill and on/off headlight buttons. Includes 9 female bullet connectors, you may need to adapt the connectors to fit your wire harness.
Handlebar
Vintage MX Custom Type Bar - Chrome. Width 33" - Rise 4 1/2" - Pullback 6" - Center Width 7" x 7/8" Dia. Note: Not Drilled for wires
Handlebar - Black
Clubman/Cafe Bar - Black End to end length 28", length of bar arms 8 3/4" each, start of middle bend to other start of middle bend 7 1/2", outside of knurled mounting points 4 3/4", inside of knurled mounting points 3 1/4". Note: Not Drilled for wires
Handlebar
Clubman/Cafe Bar - Chrome End to end length 28", length of bar arms 8 3/4" each, start of middle bend to other start of middle bend 7 1/2", outside of knurled mounting points 4 3/4", inside of knurled mounting points 3 1/4". Note: Not Drilled for wires