Honda ► GL1100 ►
-
Here’s our hand-picked list of parts and accessories for your Honda GL1100►
- Honda
Oil Tube Plug
Oil Tube Plug, Replaces OEM # 15337-300-010
Handlebar Brake Lever Pivot Bolt & Nut Set
Handlebar Brake Lever Pivot Bolt & Nut Set. This is the Set that Fastens the Brake Lever in Place. Includes One Bolt with One Nut. Replaces OEM # 90114-MA5-671 (Bolt) and OEM # 94050-06000 (Nut)
Carb Bolt Kit
Carburetor Bolt and Washer 35 Piece Kit. This is a Complete Bolt Kit for All 4 Carburetors.
Front Cable/ Stop Switch Clip
Front Cable Clip, This Clip Holds the Stop Switch Wires to the Cable to Keep Things Tidy. Replaces OEM # 45465-270-000
Water Pump
Water Pump Kit with Gaskets and O-Rings, Replaces OEM# 19200-MG9-681 / 19200-371-010 / 19200-371-020 / 19200-MG9-680 / 19200-371-000.
Side Cover Emblem
Side Cover Emblem, Replaces OEM# 83605-MG9-000 / 83605-MG9-010 / 83605-463-000 / 83605-463-505 Sold Each, Order the Quantity you Require
Side Cover Emblem
Side Cover Emblem, Replaces OEM# 83606-MB9-000 Sold Each, Order the Quantity you Require
Clutch Cover Hardware Set
Clutch Cover Hardware Set. Set includes the 6 Bolts and 2 Nuts Used to Fasten the Clutch Cover. Includes 4X 95801-0608500 , 2X 95801-0603500 , 2X 94050-06000
Front Reflector
Front Reflector, Replaces OEM# 33742-HB9-641 / 33741-413-003 / 33741-413-013 Amber Reflector with Black Plastic Ring. 2 Segments in the Reflector (Instead of 6 Like the OEM).
Rear Fender Bolt Set
Rear Fender Bolt Set of 2, Replaces OEM# 90102-371-000 These are the large main bolts that go in the middle portion of the rear fender. The grab bar bolts thread into these fender bolts.
Chrome Timing Belt Cover Set
Chrome Timing Belt Cover Set, Replaces OEM# 11511-371-010 / 11521-371-010. Spruce up your bike with a new set of chrome covers. These new covers really make these bikes look amazing!
Air Chamber Gasket
Air Chamber / Plenum Gasket, Replaces OEM# 16075-463-004 Fix those unseen air leaks with this gasket.
Handlebar Clamp Hardware Set
Handlebar Clamp Hardware Set. This Hardware Set is for the Stock Type Clamp (Holder) that Attaches Over the Handlebar. Includes the 4 Bolts that Fasten the Handlebar Clamp in Place and 4 Covers that Snap into the Screw Tops to Give it a Super Clean Look! Replaces OEM# 91456-371-770 X4, 90185-371-000 X4
Headlight Reflector Rubber Base
Headlight Reflector Rubber Base, Replaces OEM# 33743-375-000 This is the rubber base that the headlight reflector attaches to. Sold Each, order the quantity you require
Front Brake Caliper Bolt Set
Front Brake Caliper Bolt Set, Replaces OEM# 90123-371-000. Each set includes 2 bolts and 2 washers - enough for either the left or right caliper. If you would like bolts for both sides purchase 2 sets.
Fuel Tank Rubber "C"
Fuel Tank Rubber "C" - Replaces OEM# 17616-371-000 This rubber is used with the stock bolt and collar to attach through the hole near the top of the fuel tank.
Horn ~ Similar to Stock Style
Horn with Chrome Cover - 12 Volt 3 Amp - 103 Decibel - This is Not identical to the stock type but has a somewhat similar design to the stock type on these bikes.
Oil Pump Rebuild Kit
Oil Pump Rebuild Kit Each Kit Contains: Each Kit Contains 91207-580-015 (Oil Seal 10x25x7) x1, 91208-MN1-771 (O-Ring 11x15x3) x1, 91302-200-000 (O-Ring 33.5x3) x1, 94201-30450 (Split Pin 3.0 x45) x1, 15128-371-000 (Oil Passage Gasket) x1, 15229-371-000 (Clutch Oil Pump Gasket) x1.
Fuel Petcock Assembly
Fuel Petcock (Gas Tap) Assembly with Port O-Rings, Replaces OEM# 16950-371-025 / 16950-MG9-005 This petcock has a "reserve" function that did not appear on the original GL1200 petcock. Outside diameter of port is 6 mm and inside diameter is 4mm